The no shutdown command fixes administratively down (interface disabled by software). It does fix hardware down (no cable, no carrier signal). The "virtual device will start disconnected" message is a hardware-level notification. You cannot fix it with IOS commands; you must fix it in the emulator GUI. The Clock Rate Caveat (DCE vs DTE) Even after you connect the virtual cable, you might still face a down/down or up/down status. After fixing the "start disconnected" message, ensure you have a clock rate set on the DCE side.
The root cause? The console log from boot clearly showed: "Virtual device serial0 will start disconnected" and "Virtual device serial1 will start disconnected" . The student had never connected the cables from the router to the Frame Relay switch. virtual device serial0 will start disconnected
If you have ever fired up a Cisco router in Dynamips , GNS3 , EVE-NG , or Cisco Packet Tracer , you have likely seen the console output slowly crawl by until it halts at a seemingly concerning line: "Virtual device serial0 will start disconnected" For many students, this message triggers an instinct to panic. Is the router broken? Is the image corrupted? Will Serial0/0 ever come up? You cannot fix it with IOS commands; you