Hsb133 Receiver 〈iPad Essential〉

// Simple receiver sketch for HSB133 const int rxPin = 2; int lastState = LOW; unsigned long lastTrigger = 0; void setup() Serial.begin(9600); pinMode(rxPin, INPUT); Serial.println("HSB133 Receiver Ready");

Do not confuse the HSB133 with a "data slicer" receiver. The output is raw digital TTL. If you are sending analog sensor data, you will need to encode it (e.g., using Manchester encoding or a dedicated encoder IC). Pairing with a Transmitter The HSB133 does not work alone. It requires a compatible transmitter. The most common partner is the HSB133-TX (a crystal-stabilized transmitter) or a simple FS1000A (though the FS1000A’s drift may negate the benefits of the HSB133).

| Pin Name | Function | Wiring Instructions | | :--- | :--- | :--- | | | Antenna Input | Connect a 17.3 cm wire (for 433MHz) or a 50-ohm SMA antenna. Do not ground this pin. | | GND | Power Ground | Connect to the negative terminal of your power supply or microcontroller GND. | | VCC | Power Supply | Connect to a clean +5V DC source. Avoid switching power supplies without filtering. | | DATA | Digital Output | Connects directly to the RX pin of a UART, a microcontroller GPIO, or a decoder IC (e.g., PT2272). | | GND | Secondary Ground | Connect to the same ground plane as Pin 2 for RF stability. | hsb133 receiver

HSB133 VCC → Arduino 5V; GND → GND; DATA → Pin 2.

// The HSB133 output is normally high (idle) and goes low (active) when a signal is received. if (state == LOW && lastState == HIGH) // Debounce (avoid multiple triggers from the same signal) if (millis() - lastTrigger > 500) Serial.println("SIGNAL DETECTED!"); lastTrigger = millis(); // Simple receiver sketch for HSB133 const int

| Feature | HSB133 (Classic) | SYN470R | CC1101 (SPI) | | :--- | :--- | :--- | :--- | | | Very low (digital out) | Low | High (needs SPI config) | | Current Draw | ~3.5 mA | ~5.5 mA | ~18 mA (RX) | | Selectivity | Good | Excellent | Excellent | | Price | $2 - $4 | $3 - $5 | $6 - $10 | | Best for | Simple on/off remote | Sensor networks | Frequency hopping/protocols |

The HSB133 receiver is a workhorse of the analog wireless world. It bridges the gap between unreliable toy-grade receivers and complex, expensive professional telemetry modules. Pairing with a Transmitter The HSB133 does not work alone

Always buy a few extra modules. While robust, RF modules are susceptible to ESD (Electrostatic Discharge) during handling. Ground yourself before soldering, and your HSB133 will provide years of reliable service. Have a specific question about the HSB133? Consult the official datasheet or leave a comment on your favorite electronics forum.