Fu10 Day Watching 18 Install ✔ 【TOP-RATED】
Navigate to System > Info > Version . The FU10 requires firmware v4.2.1 or higher for the “Day Boost” algorithm. If lower, update via USB. Phase 3: Image Calibration for Day Watching (Steps 9-14) Step 9: Set Scene Mode Go to Image > Scene > Day Watching (High Dynamic Range) . This disables night-mode IR LEDs and activates the WDR (Wide Dynamic Range) engine.
Press and hold the reset pinhole for 10 seconds until you hear two beeps. This ensures no legacy settings interfere with day-watching profiles. fu10 day watching 18 install
Run a full day of recording. At sunset, review 1 hour of footage from 12 PM (peak sun). Check for blown highlights or underexposed shadows. Adjust exposure compensation by ±0.3 if needed. Troubleshooting Common FU10 Day Watching Issues Even with the perfect 18-install, you may encounter hiccups. Here’s how to solve them: Navigate to System > Info > Version
Attach a compatible CS-mount lens (recommended: 6-60mm varifocal for day watching). Ensure the sensor is clean. Use the included shim if back-focus is off. Phase 3: Image Calibration for Day Watching (Steps